linux - How to configure driver in Buildroot for Moxa UPort 1110 USB serial converter?

Question

I have a board with an embedded system that is buildroot based. In "make linux-menuconfig" I would like to add the appropriate drivers for the USB-RS232 adapter "Moxa UPORT 1110". I marked in "make linux-menuconfig":

Device Drivers-> USB support -> USB Serial Converter support-> USB MoxaUPORT Serial Driver

after connecting the adapter with the device, linux will not recognize the device.

When I check "lsusb" I get:

lsusb
Bus 001 Device 006: ID 110a:1110
Bus 001 Device 001: ID 1d6b:0002

The board does not see the producer's name etc. On my Ubuntu computer I get after plugging in usb and typing "lsusb ::

Bus 001 Device 036: ID 110a:1110 Moxa Technologies Co., Ltd. 

When I check dmesg after plugging in the USB and see:

[ 9752.822985] usb 1-1: USB disconnect, device number 5
[ 9754.605939] usb 1-1: new full-speed USB device number 6 using musb-hdrc
[ 9754.768212] usb 1-1: New USB device found, idVendor=110a, idProduct=1110
[ 9754.775263] usb 1-1: New USB device strings: Mfr=1, Product=2, SerialNumber=0
[ 9754.782783] usb 1-1: Product: UPort 1110
[ 9754.786903] usb 1-1: Manufacturer: Moxa Technologies Co., Ltd.

should I check any additional settings / drivers in "make linux-menuconfig" to see the USB-R232 adapter?

question from:https://stackoverflow.com/questions/66048818/how-to-configure-driver-in-buildroot-for-moxa-uport-1110-usb-serial-converter

Answer 1

From looking at the Linux source code, I understand that you enabled the mxuport driver which does not cover the UPORT 1110. However, it looks like the ti_usb_3410_5052 driver does. You can enable it by setting CONFIG_USB_SERIAL_TI.

In the Buildroot sources I see that you must make sure that BR2_PACKAGE_LINUX_FIRMWARE_USB_SERIAL_TI is set in order to include the firmware file (moxa-1110.fw).

So, in make menuconfig enable USB TI 3410/5052 Serial Firmware under Target packages > Hardware handling > Firmware > linux-firmware > USB to Serial Firmware