Welcome to OGeek Q&A Community for programmer and developer-Open, Learning and Share
Welcome To Ask or Share your Answers For Others

Categories

0 votes
515 views
in Technique[技术] by (71.8m points)

oracle10g - Is it possible to kill a single query in oracle without killing the session?

I would like to be able to kill a user's query in Oracle 10.2.0.4 without killing their entire session. This would allow the query to end, but not log that user out of their session, so they can continue making other queries. Is this possible at all? Or is the blunt hammer of killing the session the only way to go about ending a query's execution?

See Question&Answers more detail:os

与恶龙缠斗过久,自身亦成为恶龙;凝视深渊过久,深渊将回以凝视…
Welcome To Ask or Share your Answers For Others

1 Reply

0 votes
by (71.8m points)

I found a trick. I have no idea how safe this is to play with, but it does work. There is an Oracle event, 10237, which is described as "simulate ^C (for testing purposes)".

You have to have the SID and SERIAL# of the session you want to interrupt.

Call SYS.DBMS_SYSTEM.SET_EV( sid, serial#, 10237, 1, '' ) to activate the event in the target session. Any currently executing statement should be interrupted (receiving "ORA-01013: user requested cancel of current operation"). As long as the event is set, any further statements the session attempts to execute will immediately terminate with the same error.

To deactivate the event, make the same call with the fourth parameter set to "0". The session will then be able to execute statements again.

Note that the target session has to detect that the event is set, which may take time, or may never happen, depending on what it is doing. So you can't just quickly toggle the event on and off. You would need to turn it on, verify that the statement in question has stopped, then turn it off.

Here's some sample code. This is meant to be run as an anonymous block in SQLPlus, with substitution variables "sid" and "serial" defined appropriately. You could turn it into a stored procedure with those as its parameters.

DECLARE
  l_status  v$session.status%TYPE;
BEGIN

  dbms_system.set_ev( &sid, &serial, 10237, 1, '');

  LOOP
    SELECT status INTO l_status FROM v$session
      WHERE sid = &sid and serial# = &serial;
    EXIT WHEN l_status='INACTIVE';
  END LOOP;

  dbms_system.set_ev( &sid, &serial, 10237, 0, '');
END;

与恶龙缠斗过久,自身亦成为恶龙;凝视深渊过久,深渊将回以凝视…
OGeek|极客中国-欢迎来到极客的世界,一个免费开放的程序员编程交流平台!开放,进步,分享!让技术改变生活,让极客改变未来! Welcome to OGeek Q&A Community for programmer and developer-Open, Learning and Share
Click Here to Ask a Question

...