for loop - How can I run multiple commands in just one cmd windows in Java?

Question

what I would like to do is run a batch file multiple times from a java application. Therefore I set up a for-loop that runs this code n times:

for (int i = 0; i < n; i++) {
    Runtime.getRuntime().exec("cmd /c start somefile.bat");
}

The problem is that now each time the command is run a new cmd window pops up. However, what I want is just one window that pops up at the beginning and that is used to display all data from the following command calls.

How can I do that?

Answer 1

With && you can execute more than one commands, one after another:

Runtime.getRuntime().exec("cmd /c "start somefile.bat && start other.bat && cd C:\test && test.exe"");

Using multiple commands and conditional processing symbols

You can run multiple commands from a single command line or script using conditional processing symbols. When you run multiple commands with conditional processing symbols, the commands to the right of the conditional processing symbol act based upon the results of the command to the left of the conditional processing symbol.

For example, you might want to run a command only if the previous command fails. Or, you might want to run a command only if the previous command is successful. You can use the special characters listed in the following table to pass multiple commands.

& [...] command1 & command2
Use to separate multiple commands on one command line. Cmd.exe runs the first command, and then the second command.

&& [...] command1 && command2
Use to run the command following && only if the command preceding the symbol is successful. Cmd.exe runs the first command, and then runs the second command only if the first command completed successfully.

|| [...] command1 || command2
Use to run the command following || only if the command preceding || fails. Cmd.exe runs the first command, and then runs the second command only if the first command did not complete successfully (receives an error code greater than zero).

( ) [...] (command1 & command2)
Use to group or nest multiple commands.

; or , command1 parameter1;parameter2
Use to separate command parameters.